![]() MAX3232 TX > Arduino TX (pin 6 in my case, more on that later) Connect your sensors to Arduino analog inputs. Connect your sensors to an analog/RS232 converter. Sensors > 5v analog > RS232 conversion > 2.5mm Stereo Jack > Tactrix > Happiness You'll connect your sensors to an a device than can receive their 5v analog input and transform it an RS232 data stream which will be sent to through a 2.5mm Stereo Jack connected to the OpenPort jack input and add a bit of configuration and that's it. Technically something like this could work but I haven't properly read the documentation nor do I own the product. ![]() I use an Arduino+MAX3232 but you could technically use anything that is able to produce an RS232 signal/stream that respect the OpenPort protocol. ![]() This won't be a very detailed how to but you should be able to get the idea. ![]() Long story short, I've found out that Tactrix has RS232 input which can be used very easily to add any amount of external sensor, eg: oil pressure, fuel pressure, O2 sensor, Knock sensor, WMI flow sensor, etc. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |